MAGNATRAC RT1150 Operator / Technical Manual page 20

Rear Drive Chain - Lubricate & maintain proper
chain tension in Crawler's Rear Drive.
Check Service section of this manual for
complete rear drive chain tensioning.
Drive Belt - Check drive belt tension & condition.
Check Service section of this Manual for
complete Drive Belt tensioning & removal
procedures.
Transaxles - Inspect control linkages for any
loose or damaged parts. Check for any
partially engaged bypass valves.
General Once-Over - Check for loose nuts and
bolts and any signs of premature wear.
Correct any problems immediately. Con
tact factory with any questions or requests
for help.
100 HOURS (CHG OIL)
100 HOURS (CHG OIL)
Drive Belt - Check drive belt tension & condition.
Check Service section of this Manual for
complete Drive Belt tensioning & removal
procedures.
Engine Oil - Drain and refill per recommendations
in Engine Owner's Manual.
Spark Plug - Check-adjust spark plug. Follow en
gine manual.
Spark Arrestor - Clean spark arrestor, if applica-
ble. Follow engine manual.
Transaxles - Inspect control linkages for any
loose or damaged parts. Check for any
partially engaged bypass valves. If first
100 hour service, an initial transaxle oil
& filter change at 100 hours is advised.
See service section of this manual, &
transaxle Service & Repair Manual.
300 HOURS
300 HOURS
Drive Belt - Check drive belt tension & condition.
Check Service section of this Manual for
complete Drive Belt tensioning & removal
procedures.
Spark Plug - Replace spark plug. Follow engine
manual.
Air Filter - Replace Air Filter at this time. Filters
can be purchased through the Struck Cor-
poration or through local engine dealers.
Follow engine manual.
Spark Arrestor - Clean spark arrestor, if applica-
bale. Follow engine manual.
Other Engine Adjustments - Follow engine man-
ual.
Transaxles - Inspect control linkages for any
loose or damaged parts. Check for any
partially engaged bypass valves.
400 HOURS
400 HOURS
Drive Belt - Check drive belt tension & condition.
Check Service section of this Manual for
complete Drive Belt tensioning & removal
procedures.
Hydraulic Oil - Completly drain and fill hydraulic
oil tank. See service section of this man-
ual.
Transaxle Oil - Drain tranaxle oil, change filters
and add new. See service section of this
manual, & transaxle Service & Repair
Manual.
Transaxles - Inspect control linkages for any
loose or damaged parts. Check for any
partially engaged bypass valves.
20