MAGNATRAC RT1150 Operator / Technical Manual page 29

Hyd. Pump
Mount
Step 5: Using the picture above and below as a
guide, push pry bar forward against hydraulic
pump mount. Hydraulic pump mount should move
forward, and tighten the drive belt. At this time,
tighten bolt 1 & 2 to hold the position of the hy-
draulic pump mount and belt.
Note: You may need to insert a short block of
wood into the area shown below. This allows
you to gain enough leverage to push the Hy-
draulic Pump Mount forward.
1
Pry Bar
2
Push Forward
Step 6: Tighten bolt 3 & 4 and their corresponding
nuts. (PICTURE BELOW) The nuts are on the un-
derside of the "raised body pan." Note: Using
ratchet extension with socket and wrench,
have 1 person hold the nut from the underside
of the body pan, while another person loosens
(but doesn't remove) the bolt, from the top.
You should not need to remove any front
counterweight.
4
Hyd. Pump
Mount
Step 7: Push idler pulley to the driver's left, just
enough too make contact with the drive belt,
then push another 1/2", tighten pulley bolt & nut.
See picture below.
Pulley Bolt
1. Push idler to make contact
with belt.
2. Then push another 1/2".
3. Tighten pulley bolt & nut.
29
3
Idler Pulley