Table of Contents
Advertisement
Step 9: Slowly move track control handles A and
B, in both forward and reverse directions, approx.
5 to 6 times. See picture below.
Forward
Neutral
Reverse
Control A
Step 10: Shut off the MAGNATRAC at this time.
Keep your MAGNATRAC brake lever disengaged
at this time.
Step 11: Check the oil level of each expansion
tank as shown below. Shut off the unit.
Step 12: If low, add 20W50 Engine Oil through
the expansion tanks, until the "Full Cold" line is
reached on the plastic expansion tank.
Note: It may be necessary to repeat Steps 1
through 12, until all air is purged from the sys-
tem. When both transaxles operate at normal
noise levels and move smoothly forward and
reverse at normal speeds, then the transaxle
is considered purged.
Forward
Neutral
Reverse
Control B
Expansion
Tank Cap
Full Cold Line
FINAL STEPS
To reinstall transaxle oil filter access panels, use
Step 7 on page 35.
To lower the machine to the ground, work Step 7
through Step 1 in reverse order on pages 34 & 35.
RETURN TO NEUTRAL SETTING
The return to neutral (RTN) mechanism on the
transaxle is designed to set the directional control
into a neutral position when the operator releases
the track control handles (Control A & B). If you
notice that your track drive handles do NOT return
to exact neutral when you release them, do not be
alarmed. Due to our design, you may have to
manually move the handles back to center. If this
is excessive, and one track continues to move
after you release the drive handle, please contact
our technical support team prior to making any ad-
justments to the return to neutral adjusting screw.
Adjustments to the return to neutral (RTN) adjust-
ment screw are shown in the transaxle manual,
page 13, however, we HIGHLY advise to talk with
our technical support team first, to see if there's
other issues with the transaxle or Struck Corp.
linkage.
OTHER TRANSAXLE ITEMS
Please contact the Struck Technical Support Team
if you have any questions prior to starting any of
the above mentioned procedures, or prior to mak-
ing any other transaxle adjustments.
Below are ways to contact the Struck Techni-
cal Support Team.
Phone:
(262) 377-3300 local
(877) 828-8323 toll-free
Text:
(262) 278-9298
Email:
support@struckcorp.com
Web:
struckcorp.com/contact-us
40
Advertisement
Table of Contents
