Table of Contents
Advertisement
Step 8: To ensure that both Front Idlers (on each
side) have moved rearward, using a mallet, pound
on each track & front idler in the area shown
below. Do this to both sides. See below. Your front
idlers should have moved rearward during Steps
4-8.
#2065
Step 9: To tighten the Drive Chains, start rotating
clockwise the Locknut located on left and right
lower rear of Body. To draw Rear Axle back
evenly, turn one Locknut 1/2 turn, then go to the
other side and tighten the other Locknut 1/2
turn...use this back and forth procedure until both
#1805 Drive Chains are reasonably tight...not
"bow-string" tight, but about a 1/4" of "sag" in
the slack strand when the balance of the chain is
taught. See below.
#1805
"Sag"
Locknuts
NOTE: When satisfied that both #1805 Drive
Chains are tightened evenly, retighten the four
Bolts holding the two "Inner" Rear Plates on left &
right side of Body. See the 2 pictures on the left
hand side of the previous page. (Left & Right Rear
Views).
Thoroughly lubricate your Drive Chains at this
time, if you did NOT do it earlier in the process.
Replace Seat Assembly, Arm Rests and Rear
Cover and close Hood...secure all with #1866
"threaded" Knobs.
Front
Idler
Pound Rearward
#4540
#1650
On
Off
#1829
#1825
Note: Skip to page ??, step # if you have fin-
ished tensioning your rear drive chains.
CHAIN REPLACEMENT
To replace your rear drives chains, first follow
Steps 1-8 on pages 44-46.
Step 1: Remove old drive chains if still connected,
by finding the retaining clip that holds the master
chain connector in place. Insert a small flat head
screwdriver under the retaining clip, pull upward.
The master connector should now separate fro
mthe drive chain.
Step 2: Fully loosen "Rear Nuts" on both left &
right sides, until the nuts are at the end of the bolt.
See below.
Right Rear View
"Outer" Rear Axle Plate
Adjustment
Slot
1690
Washer
Rear Nut
(Fully loosen
until at end
of bolt)
Step 3: Push Rear Drive Sprockets on both
sides forward, until you reach the end of the slot
on the "Outer" Rear Axle Plates. See above.
47
#1625
#4562
#1688
#1674
#1608
Plug
4540
Sprocket
Hub
Rear
Drive
Push
Advertisement
Table of Contents
