Terminals Description - Danfoss Holip HLP-C+ Series Instructions Manual

⑵ Function Description of Circuit Terminals
1. Main Circuit Terminals Arrangement
2. Control Circuit Terminals Arrangement
FA FB FC DRV FOR REV RST SPL SPM SPH GND AM
3. Function description of main circuit terminals
Symbol Function Description
Input terminals of AC line power.(230V class, for
R.S.T both single/three phase, single phase connected to
any two phases)
U.V.W Output terminals to motor.
P.P.r External braking resistor terminals.
Ground terminals: the third kind of grounding for
E 230V and special grounding for 400 V of Electrical
Engineering Regulations.
4 、 Function description of control circuit terminals
Symbol Function Description
FOR Multi-function input 1
REV Multi-function input 2
RST Multi-function input 3
SPH Multi-function input 4
SPM Multi-function input 5
SPL Multi-function input 6
Common end for digit
GND
control signals
Factory setting
Forward run
Reverse run
Reset
High speed
Intermediate Speed
Low Speed
-  -
+
HLP-C Inverters
VI AI +10V