Playing The Built-In Test Message To An Ipam400 Local Output - ASL INTERCOM iPAM400 Product Manual

6.3.1.5.4

Playing the Built-in Test Message to an iPAM400 Local Output

This option will cause the iPAM400 to play the built-in test message to one of its own local outputs.
To Play the Built-in Test Message to an Output:
1. Run the Setup Tool as follows, if not already running.
a. Connect to the iPAM400 either remotely or locally, as described in Section "6.2 Connecting to
the iPAM400" (page 59).
b. Run the Setup Tool by entering the following command: /dva/bin/vipet_setup
2. Choose the "Test" option from the main menu by entering "5"
3. Choose the "Play test message to an output" from the test menu by entering "4".
A list of local outputs will be shown.
4. Choose the required output by entering its option number.
5. The test message (/dva/msgs/test.wav) will be played to the chosen output, and then the current
menu options will be shown for further selections.
It is not possible to terminate the message before it completes its cycle.
6. If no further tasks are to be performed, then return to the main menu (if not already done) and enter
"X" to exit the Setup Tool.
iPAM400 – Product Manual
U-0629-0171.doc – Issue: 04 complete, approved
Page 78 of 138