Manufacturer's Information; Delivery; Packaging; Transport - GEM R90 Operating Instructions Manual

Metal disco check valve
Table of Contents

Advertisement

8 Manufacturer's information

8.1 Delivery

● Check that all parts are present and check for any dam-
age immediately upon receipt.
The product's performance is tested at the factory. The
scope of delivery is apparent from the dispatch documents
and the design from the order number.

8.2 Packaging

The product is packaged in a cardboard box which can be re-
cycled as paper.

8.3 Transport

1. Only transport the product by suitable means. Do not
drop. Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal reg-
ulations / environmental protection laws.

8.4 Storage

1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their
spare parts.

9 Installation in piping

9.1 Preparing for installation

Danger - bodily injury!
▶ Risk of severe injury.
Depressurize the plant before per-
forming any work on the product.
Observe correct handling procedures.
The equipment is subject to pressure!
▶ Risk of severe injury or death.
Depressurize the plant.
Completely drain the plant.
Corrosive chemicals!
▶ Risk of caustic burns.
Wear suitable protective gear.
Completely drain the plant.
www.gemu-group.com
DANGER
WARNING
WARNING
Hot plant components!
▶ Risk of burns.
Exceeding the maximum permissible pressure.
▶ Damage to the product.
Provide precautionary measures against exceeding the
maximum permitted pressures caused by pressure
surges (water hammer).
Use as step.
▶ Damage to the product.
▶ Risk of slipping-off.
Choose the installation location so that the product can-
not be used as a foothold.
Do not use the product as a step or a foothold.
Suitability of the product!
▶ The product must be appropriate for the piping system
operating conditions (medium, medium concentration,
temperature and pressure) and the prevailing ambient
conditions.
15 / 21
9 Installation in piping
CAUTION
Only work on plant that has cooled
down.
CAUTION
CAUTION
NOTICE
GEMÜ R90

Advertisement

Table of Contents
loading

This manual is also suitable for:

R91

Table of Contents