Operation; Replacing Lamps - LEGRAND pass & seymour LightSense PSWS Installation Instructions Manual

OPERATION

– –
– –

Replacing Lamps

When a lamp must be replaced, tap
conducting maintenance on the load, turn off the circuit at the circuit breaker.
Power Fail Memory
After a power failure, all LightSense™ devices automatically return to the state
that they were in immediately prior to loss of power. All configuration and scene
control information is preserved.
Visit our website for FAQs: www.passandseymour.com
Tap once
Press and hold
Tap once
Press and hold
When you see
in the
instructions,
touch the top
of the switch
as directed.
Turn circuit ON
Turn circuit ON
Turn circuit OFF
Turn circuit OFF
to turn off the circuit. If you are
When you see
in the
instructions,
touch the
bottom of the
switch as
directed.