Use; Mode Of Operation; To Program A Scenario - LEGRAND 5 745 03 User Manual

2 Use

Mode of operation

2.1

2.1.1 To program a scenario

Your Scenario Control can program up to four scenarios, saving them
in a Scenario Module (F420) which has been enabled for programming.
To save one or more scenarios:
F420
DEL
light cinema
night relax
t > 4 s
ON
OFF
In the Scenario Module press the pro-
gramming enabling pushbutton.
Its led becomes green:
the module is enabled.
Press the key to program for more than
four seconds.
When the led lights up release the key.
The led flashes to indicate that the pro-
gramming mode has been activated.
ON
OFF
Set the sequence of commands which
make up the scenario.
light cinema
night relax
Repeat the sequence to add, edit or cancel a scenario command.
light cinema
night relax
At the end of the programming you should disable the possibility
of editing the scenarios by pressing the Scenario Module (F420)
enable/disable pushbutton. The led becomes red.
on
Scenario control
Press the key to end the programming.
Press the corresponding key to activate
the scenario required.
on
9