Table of Contents
Advertisement
•
•
Omnikey6121
•
•
SCM_SCR3310
•
•
CHERRY_ST-1044U
•
•
ACS ACR38U-A1
•
•
ACS ACR38T-IBS-R
•
•
InfoLink_IT100
Important: It is highly recommended that you install the proprietary driver of your
card reader onto the computer(s), which is either shipped with the card reader or
can be downloaded from the official website of the card reader's vendor. If not, the
card reader may not function properly.
Secure Installation Guidelines
•
•
DO NOT attempt to connect or install the following devices to the computers connected to the
Secure Switch.
• TEMPEST computers
•
•
• Telecommunications equipment
•
• Frame grabber video cards
• Special audio processing cards
•
•
•
Before installation, make sure the power sources to all devices involved in the installation are
turned off.
•
•
Hot-swapping of the console monitor is NOT supported.
You must power OFF the Secure Switch and console monitor before changing or
re‑connecting the monitor. Power them back ON after finishing the monitor connection.
•
•
A computer should only be powered on after all of the cable connections to the Secure Switch are
finished, including video, USB and audio.
•
•
Important safety information regarding the placement of this device is provided in the topic titled
Safety Instructions (admin) in the Administrators Guide. Please review it before proceeding.
Secure Operation and Administration
Stacking
The Secure Switch features a rugged, metal enclosure which provides stability and allows the device to
be stacked on the desktop.
It can be placed on any level surface that can safely support its weight and the weight of all attached
cables.
Ensure that the surface is clean and free of materials that can block the exhaust vents or otherwise
interfere with normal operation of the Secure Switch.
Installation Procedure
To install your Secure Switch system, power OFF all devices and then follow the procedure below, which
corresponds to the numbers of the installation diagram following this topic.
16
Advertisement
Table of Contents
