Administrator Logon - LEGRAND Raritan RSS4-102 Administrator's Manual

Administrator Logon

After Installation for Administrator Logon
1. Open a text editor on the connected computer.
2. Use the console keyboard for the following procedure:
a. Press and hold down the [Ctrl] key, and then press the [F12] key.
Ctrl + F12
b. Release the [Ctrl] and [F12] keys.
c. Press the [L] key. Then press [Enter].
After successful input of the key sequence, you will enter the Administrator Logon mode
and be prompted for authentication in the text editor.
3. In the text editor, you will be prompted for the default Administrator password.
ATTENTION:
-- The default Administrator password is used for the first-time Administrator Logon only.
-- To maximize security and to prevent unauthorized access to Secure Switch, change the default logon
password after your first successful logon. Once changed, the default Administrator password CANNOT
be restored with Reset to Factory Default.
4. The default Administrator password for the first-time logon is:
ABCD@xyz#2468!
• The password is case-sensitive.
• Press the [Shift] key for uppercase letters and special characters.
5. A [Logon OK] message appears when the password input is correct. If the password input is wrong,
you will be prompted for password input again.
a. If logon attempts fail for 3 times, the Administrator Logon mode will be terminated
automatically. Access to the Administrator Logon mode will be blocked for 15 minutes.
b. If logon attempts fail for 9 times, the Secure Switch becomes inoperable permanently. Remove it
from service immediately and contact your Raritan dealer.
6. After the [Logon OK] message appears, type the command "LIST" and press [Enter] for Administrator
Functions.
• The command "LIST" displays Administrator Functions.
7. For maximum security, Administrator must change the Administrator Logon password via
Administrator Functions after the first successful logon. The new password should comprise:
• 8 to 22 characters in length
• A minimum of 1 lowercase letter
• A minimum of 1 uppercase letter
• A minimum of 1 numeric character
• A minimum of 1 special character
DO NOT use the default Administrator password as your new password. Administrator will
be prompted for entering the new password again for confirmation.
After the new Administrator Logon password is set, the default Administrator Logon
password will NOT be restored even with the "Reset to Factory Default" command.
16
(on page 15),