5
Right click on the Solution Explorer project
name at the upper right of the Power PMAC
IDE screen, select Build and Download
All Programs, and execute Build and
Download.
6
Make sure that there are no errors in the
Output window.
3-6-3
Setup of Control Commands
Set the feedback signal of the Galvo Scanner to the current position.
1
Type the
Motor[3].pDac=Sys.Udata[0].a com-
mand in the Power PMAC IDE Termi-
nal.
2
Type the
Motor[4].pDac=Sys.Udata[0].a com-
mand in the Power PMAC IDE Termi-
nal.
Application Guide Laser Application (O052)
3 Connection Procedures
3
3-47