Setup Of The Galvo Scanner; Wiring Of Devices - Omron CK5M-CPU1 1 Series Application Manual

3 Connection Procedures
3-6

Setup of the Galvo Scanner

3-6-1

Wiring of Devices

The figures below show how to wire the CK3M to the Galvo Scanner.
varioSCAN
Connect the sections a and b in the above figures as follows.
a. Connection between the Controller and the Galvo Scanner
Connect the XY connector of the CK3W-GC2200 to the SL2-100 connector of the intelliSCAN with
the dedicated cable CK3W-CAG03A.
CK3W-GC2200
Signal
XY-IN+
XY-IN-
XY-OUT+
XY-OUT-
b. Connection between the Controller and the dynamic focusing unit
Connect the Z connector of the CK3W-GC2200 to the DIGITAL IN connector of the DSIB-SL with
the dedicated cable CK3W-CAG03A.
3-44
DSCB
Pin
1
6
2
7
a
DSIB-SL
b
IntelliSCAN
IntelliSCAN
Signal Pin
5
DATA OUT+
DATA-OUT- 9
DATA-IN+ 1
DATA-IN- 6
Application Guide Laser Application (O052)
CK3W-AX2323
CK3W-GC2200