Introduction; Qualified Persons; Read This Instruction Sheet; Proper Application - S&C TripSaver II User Manual

Introduction

Qualified
Persons
Read this
Instruction
Sheet
Proper
Application
Retain this
This instruction sheet should be available for reference wherever a TripSaver II controller module
and USB Transceiver are to be used. Retain this document in a location where it can be easily
Instruction
retrieved and referred to.
Sheet
2 S&C Instruction Sheet 461-508LD
The equipment covered by this publication must be installed, operated, and maintained by
qualified persons who are knowledgeable in the installation, operation, and maintenance
of radios in electric power distribution equipment, along with the associated hazards . A
qualified person is a radio technician who is qualified to install transmission-power-limited
radio equipment per FCC Part 15 and who is trained and competent in:
• The skills and techniques necessary to distinguish exposed live parts from nonlive parts
of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
• The proper use of the special precautionary techniques, personal protective
equipment, insulating and shielding materials, and insulated tools for working on or near
exposed energized parts of electrical equipment
These instructions are intended only for such qualified persons . They are not intended to
be a substitute for adequate training and experience in safety procedures for this type of
equipment .
Thoroughly and carefully read this Instruction Sheet before programming, operating, or
maintaining the TripSaver II controller module and USB transceiver .
The equipment in this publication is only intended for a specific application . The application
must be within the ratings furnished for the equipment .
The controller module located inside the TripSaver II Cutout-Mounted Recloser is ONLY
intended for use inside the TripSaver II recloser and has not been approved for any other
use . DO NOT disassemble the TripSaver II recloser . Opening the recloser will void the
manufacturer's warranty, and could cause minor injury . There are no user-serviceable parts .
The controller module is located inside the TripSaver II Cutout-Mounted Recloser . It has
been evaluated for use only inside the TripSaver II recloser . Do not expose it to moisture . Do
not use it outside the TripSaver II recloser enclosure, and do not use it for any purpose other
than for which it is intended .
WARNING
NOTICE
WARNING
CAUTION
NOTICE