Code Setting For The Test Strips - EKF Diagnostics SensLab Lactate Scout Vet Instruction Manual

1.6 Code setting for the Test Strips

Test Strips exhibiting a two-digit code which
must be entered when setting up the Lactate
Scout Vet or when using Test Strips from a
new Test Strip container; this code is printed
on the label of the Test Strip container.
First switch on the Configuration and Display
mode by holding down the OK button for two
seconds . Press the OK button again. The
4
code setting menu will open. The symbol line
will display "CODE" .
5
Enter the two digits of the Test Strip code,
starting from the left. Enter the digits of the
code using the arrow keys and confirm by
-
pressing the OK button . A signal tone
6 7
will confirm that the code has been set. The
Lactate Scout Vet measuring system is now
ready to take measurements using Test Strips
-
with this code .
8 9
You can now either insert a Test Strip or
switch off the device.
12