Mitsubishi Electric MELSEC-Q00U(J)CPU User Manual page 355

(4) Turning off the annunciator and processing
(a) Turning off the annunciator
The following instructions can be used.
instruction
• RST F
This is used to turn off the annunciator number that was turned on with the SET F
instruction
• LEDR
This is used to turn off the annunciator number stored in SD62 and SD64.
instruction
• BKRST
This is used to turn off all of the annunciator numbers within the specified range.
instruction
• OUT F
One annunciator number can be turned on or off with the same instruction.
However, even if an annunciator number is turned off with the OUT F
described in Page 354, Section 4.2.5 (4) (b) is not performed.
If the annunciator is turned off with the OUT F
instruction is required.
Turning off annunciator 5 (F5)
Ex.
Display reset input
Turning off all of the turned-on annunciator numbers
Ex.
Display reset input
For details of each instruction, refer to the following.
MELSEC-Q/L Programming Manual (Common Instruction)
Fault detection program
(Annunciator ON program)
RST F5
Fault detection program
(Annunciator ON program)
BKRSTP F0 K10
instruction, the off processing
instruction, execution of the RST F , LEDR, or BKRST
Program that turns off
annunciator 5 (F5)
Program that turns
off F0 to F9
CHAPTER 4 DEVICES
instruction.
4
353