Advertisement
Available languages
Available languages
2. Pull the orthosis over the foot (fig. 1) and lace up like a shoe (fig. 2).
3. Next, apply the stabilizing straps as follows: Lay the outer strap over
the instep and pass it from inner (medial) side under the foot (fig. 4)
and attach to the corresponding hook and loop closure on the ankle.
4. Next, lay the inner strap over the instep, pass it from the outer (lateral)
side under the foot and attach to the corresponding hook and loop clo-
sure on the ankle (fig. 5).
5. If full weight-bearing of the foot has been allowed by the physician, the
stabilization straps may be re-tightened (fig. 6).
2.3 Instructions for Use and Care
The orthosis must be used in strict conformity with the indication. The phy-
sician's instructions must be strictly observed.
Material: Textile pads: velour/PU; inner side of the textile: PU; hook and
loop closures: nylon straps
Cleaning: Use a slightly moistened cloth to clean the outside of the ortho-
sis. Hand-wash the textile elements in 30°C warm water with a standard
mild detergent. We recommend closing the hook and loop closures before
washing to keep them functional for a long time. Rinse thoroughly so that
all residual detergent is removed. Let air dry. Do not expose to the sun and
do not use oven or radiator heat for drying.
If need be, the shoelaces can be replaced.
Disposal after usage: The material used in the product is recyclable and
should be disposed of accordingly.
3 Further Usage Restrictions
The product is designed for use on one patient only. Re-use of the product
is not permitted.
The daily duration of use and period of application are dependent on the
medical indication.
4 Liability
The manufacturer's warranty applies only if the device has been used
under the conditions and for the1 purposes described. The manufacturer
recommends that the device be used and maintained according to the
instructions for use.
10
Advertisement
