Table of Contents
Advertisement
Storage
8. Storage
8.1 Place the Machine in Storage
After the season's use and the log splitter is going to be
put away in storage, it should be thoroughly inspected and
prepared. Repair or replace any worn or damaged components
to prevent any unnecessary down time at the start of next
season. The log splitter can have a long, trouble-free life by
following these steps:
IMPORTANT! Refer to the engine manufacturer's manual
for information specific to engine storage.
1. Fully retract the cylinder ram.
2. Do one of the following:
- If the machine will be in storage for one to three
months, add stabilizer to the engine fuel and drain the
carburetor.
- If the machine will be in storage for longer than three
months, replace the engine fuel with an alkylate or
appropriate engineered fuel. These fuel types prevent
the buildup of insoluble solids (deposits) in the engine.
For more information, see Engine Fuel on page 34.
For instructions, see Replace the Engine Fuel.
3. Thoroughly wash the machine using a pressure washer to
remove all dirt, mud, debris, and residue.
4. Inspect the wedge, cylinder ram, push block and wear
plates for damage or entangled material. Repair or replace
damaged parts. Remove all entangled material.
5. Touch up all paint nicks and scratches to prevent rusting.
6. Turn fuel valve OFF. Add fuel stabilizer to the fuel tank.
7. If the splitter is to be stored for longer periods
(over 6 months), follow the engine manufacturer's
recommendations for storage preparation.
8. Store the machine in an area away from human activity.
9. Select an area that is dry, level and free of debris to park the
log splitter.
10. If the log splitter is not stored inside a building, cover with a
waterproof tarp. Tie securely in place.
11. Do not allow children to play on or around the stored
machine.
8.1.1 Replace the Engine Fuel
Before you replace the fuel, read and understand
the information under Engine Safety on page
10.
1. Remove the current fuel from the engine.
Operate the machine until the fuel tank is empty or drain the
fuel tank and properly dispose of the fuel.
2. Add new fuel to the engine.
For instructions, see Add Fuel to the Engine on page 25.
3. Start the machine.
For instructions, see Start the Machine on page 27.
4. Wait five to 10 minutes for the fuel to flush the carburetor.
5. Stop the machine.
For instructions, see Stop the Machine on page 27.
8.2 Removing the Machine from
Storage
1. Review and follow the Pre-operation Checklist. See page
37
2. Review safety and operation procedures. See page 8.
32
WXR720/L, WXR740/L
WARNING!
Log Splitter
Advertisement
Table of Contents
