Transport; Transport Safety; Prepare For Transport - Wallenstein WXR700 Series Operator's Manual

Table of Contents

Advertisement

Transport

7. Transport

7.1 Transport Safety

• Comply with local laws governing safety and transporting
of machinery on public roads.
• Do not exceed 50 mph (80 km/h) when towing this
machine. Slow down for rough terrain and cornering.
• Do not transport or move the log splitter with the engine
running.
• Be sure the trailer is hitched correctly to the towing vehicle
and a retainer is used through the hitch mechanism.
• Always attach safety chains between the hitch and the
towing vehicle. Cross the chains underneath the trailer
tongue.
• Check wheel lugs and tighten if required. Inspect rims for
damage.
• Inspect tires for cuts or damage. Check tire pressure and
adjust if required.
• Ensure the stability jacks are raised and secured with the
latch pin.
• Make sure tow vehicle is fitted with the correct size (2 in)
towing ball.
• Make sure fuel and hydraulic tank caps are on tight to
prevent spills while transporting.
• Clean all debris off the splitter. Remove any tools or other
loose items.
• Check that all the lights, reflectors and other lighting
requirements are installed and in good working condition.
• Never allow riders on the machine.
• Be a safe and courteous driver. Always yield to oncoming
traffic in all situations, including narrow bridges,
intersections, and so on.
• Watch for other traffic when near or crossing roadways.
• Do not drink and drive.
• Before transporting, perform a walk-around inspection to
ensure everything is safe.

7.2 Prepare for Transport

• On a WXR740 or WXR740L log splitter, make sure the
pivoting main frame is fully lowered to horizontal. The lock
pin in the pivoting splitter beam must be fully engaged.
• Turn the fuel OFF when transporting.
• Clean all debris from the splitter that could fall off in
transport.
• Check tire pressure. Inspect for cuts or damaged rims.
• Check lug nuts and re-torque as necessary. Inspect again
after 20–25 mi (32–40 km). Check weekly. See page 42.
• Inspect and replace any axle dust caps that are missing,
damaged or leaking.
• Always be in compliance with all applicable local
regulations when transporting.
Figure 24 – Lock pin is fully engaged (WXR740)
30
WXR720/L, WXR740/L
Log Splitter

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wxr720Wxr740Wxr720lWxr740l11002341100217

Table of Contents