Table of Contents
Advertisement
Step 3: Install and Configure the Lattus A10 Server
Install the OS from the USB Image
20
12 Press ENTER to start the installation. The remaining part of the OS
installation is non-interactive.
At the end of the installation, a screen prompts you to reboot the
system, as shown below.
13 Select Reboot.
Note: The Eth0 port is now configured as the service port, with
an IP address of 10.17.21.1.
If a boot disk is not found, go into the PERC settings by pressing
Control R during bootup and make virtual disk 6 the boot device.
Lattus A10 Access Node Installation Guide
Advertisement
Table of Contents
