Table of Contents
Advertisement
Operation, Setup, and Maintenance
Leveling System Controls
The leveling controls on the Home Screen are shown below. The monitor and controls are located to the right
side of the Pro 700 monitor.
The Road/Field Mode (A) must be in the Field selection for leveling functions to work. If it is in the Road Mode then
the leveling functions are disabled. Pushing combine's Road/Field button toggles the leveling system between
Road and Field.
AUTO: Pushing the Auto/Manual Leveling Button (B) once will toggle between Auto & Manual. When Auto is
showing on the display (C), this means automatic leveling operation is engaged. The automatic leveling controller
monitors changes in slope and corrects chassis position to maintain a level chassis position. The Manual Left/
Right Leveling Buttons (D, E) will override the automatic leveling controller while the switch is depressed. Upon
release of the switch, the leveling system will return to automatic leveling mode.
MANUAL: Push the Auto/Manual Leveling Button (B) once to enter the Manual Leveling mode (Manual will be
displayed). In Manual mode the Manual Left/Right leveling switches will level the combine left and right. When
the switch is released the combine chassis will maintain its current position.
A - Road/Field
B - Auto/Manual Switch
C - Auto/Manual Indicator
D - Manual Left
E - Manual Right
Leveling Controls: Located on the
right side of the JD monitor. These
switches allow for Auto/Manual control
(B) and Left/Right leveling (C, D).
D-171206CMA01C
Home
Slope: 1
Menu
D
Hillco Technologies, Inc.
22
C
Monitor defaults to Road Mode
MAN
each time system is powered
up. This is done to prevent
any accidental leveling. The
Road/Field mode is controlled
ROAD
by the combine's Road/Field
A
B
D
E
Notice
switch.
B
E
Sept, 2022
Advertisement
Table of Contents
