Table of Contents
Advertisement
Mechanical Leveling Cylinder Stops
Some tire configurations may come into contact
with the side panel when the combine is leveled
over. Limit switches will prevent this contact,
however, Hillco requires installing mechanical
leveling cylinder stops. This will prevent damage
in the event of hydraulic or electrical failure. After
setting the carriage angle limits verify there is 1"
between the tire and the closest contact point
or 1/4" between the driveshafts and the leveling
system chassis. Add cylinder stops to prevent
the cylinder from over-leveling the combine.
Contact Hillco for these cylinder stops.
Carriage
The carriage is designed to support the
combine's chassis while allowing the combine
to rotate through full range of motion. It consists
of an undercarriage and an overcarriage. The
drive wheels, final drives, and transmission are
mounted to the undercarriage. The overcarriage
bolts to combine's axle and chassis.
leveling cylinders connect to the overcarriage
and the undercarriage.
the combine chassis seven inches to prevent
the tires from coming into contact with the side
panels.
D-171206CMA01C
Notice
Set Carriage Angle Limits prior to
installing Leveling Cylinder Stops.
The
The carriage raises
Hillco Technologies, Inc.
A
A - Mechanical Leveling Cylinder Stops
5/8 inch - Part # MC-137251
1/8 inch - Part # MC-137501
B
B - Transmission
C - Overcarriage
D - Undercarriage
E - Counter-Balance Valve
F - Leveling Cylinders
16
C
D
Sept, 2022
Advertisement
Table of Contents
