Critical Joint Inspection - Hillco JS7020 Operator's Manual

The Hillco Leveling System depends on several critical joints integrating the Leveling System to the
John Deere combine. These joints require specific torques for safe operation. Operational conditions
can over time loosen these joints. Hillco strongly recommends checking these joints annually.
Failure to check these joints annually may result in critical damage to the combine and leveling system.
Please reference the following pages calling out the fasteners holding these critical joints.
Rear Axle
A - Hillco Spacer to John Deere Chassis (4 bolts on MY15-18, 6 bolts MY14 and older) 235 lb-ft
B - Hillco Pin (4 bolts) 235 lb-ft
C - Cast Standoff to Hillco Spacer (4 Bolts) S600 ( -78500) 258 lb-ft, S600 (785001- ) & S700 236 lb-ft.
D - Cross Bolt (1 Bolt) 152 lb-ft
Note: If any bolts are loose, remove bolt and apply Loctite 242 to threads, install and torque.
Carriage
A - Final Drives to Hillco Carriage (6 bolts on each side of the combine. Consult Combine's
Operators Manual
B - Carriage to corner post (4 bolts on each side of combine) 235 lb-ft
D-171206CMA01C

Critical Joint Inspection

A
D
A
Hillco Technologies, Inc.
C
42
B
Sept, 2022
B