Controls And Components; Leveling Control Switches & Monitor - Hillco JS7020 Operator's Manual

Controls and Components

Leveling Control Switches & Monitor
The leveling control switches (A) and Leveling
System Monitor (B) are located on the far side
of the John Deere Monitor.
Auto/Manual Leveling — The Auto/Manual
leveling button is used to toggle between the
Automatic and Manual Modes. In Manual Mode
the chassis will not rotate until initiated by the
operator. In Automatic Mode, rotation of the
chassis is initiated by the controller as dictated
by changes in the slope. The operator can
momentarily override the controller using the
Manual Left and Right Buttons. The combine
will return to level once the button is released.
On the lower right corner of the monitor the
leveling mode (Auto or Manual) is indicated.
Manual Tilt Left and Manual Tilt Right — These
buttons allow the operator to rotate the chassis
to the left or right as desired.
The monitor gives the operator feedback such
as:
Current Slope
Current Modes
Diagnostics
Alarms
The operate can adjust settings such as:
Left/Right Limits
Level Zero point
Manual Leveling Speed
Joystick calibrations
Detail description of the monitor and adjustable
settings are later in this manual.
For operation of the leveling system see the
Operation section.
D-171206CMA01C
A - Leveling Control Switches
B - Leveling System Monitor
Manual Tilt
Left
Hillco Technologies, Inc.
11
A
Home
Home
Field
Ground Slope
0%
Slope: 27
MAX
Auto
Menu
Menu
Auto/Manual
Leveling Mode
Auto/Manual
Leveling
Manual Tilt
Right
B
Auto
Sept, 2022