Leveling Controller; Header Tilt Manifold - Hillco JH7020 Operator's Manual

Leveling Controller

The electronic leveling controller (A) is located
behind the inspection door on the operator's
platform above the leveling manifold. The
controller processes slope information and
outputs signals to the hydraulic leveling valve.
When auto leveling is activated the leveling
controller levels the chassis up to a maximum
slope of 27%.

Header Tilt Manifold

Located on the left side of the feeder house is the
header tilt manifold. This manifold diverts flow
to the cylinder in the feeder house pivoting the
header. The hydraulic valve fully integrates with
the combine's electronics to provide auto lateral
tilt. If the combine was originally equipped with
Contour Master then the stock valve is used to
control the header tilt.
D-180215CMA01C Hillco Technologies, Inc.
13
A
A - Leveling Controller
B - Header Trim Manifold
B
Sept. 2022