Hillco JS7020 Operator's Manual page 35

Carriage Angle Right Limit
This setting sets the maximum tilt to the right.
To set the carriage angle left limit, park the combine
on level ground and set the parking brake. Then raise
the feeder spout and drop the header lift cylinder safety
stop.
Select the Carriage Angle Right Limit and press Enter
(A) from the Calibration Menu.
Lean the combine to the right until either the maximum
leveling capabilities of the leveling system are reached
or contact is made between two points. The software
will automatically set back approximately one inch.
When maximum level has been achieved press the
Enter button (B). When saved is displayed, hit ESC (C)
to return to calibration menu.
Carriage Angle Right Limit
Manuall lean the combine to the right as
far as possible. Have an assistant watch
for clearance between the laddor or
styling panel and the right tires
Press Enter to save the right calibration
point
B
With certain tire selections the limit sensors can be used to prevent the need
Notice
to modify the sheet metal on the left and right side panels of the combine.
Installation of level limit stops is recommended to prevent sheet metal damage
If Level Limit Stops are used be sure that the left limit sensor has been cali-
Notice
brated with that stop in place. Damage to the cylinders or other leveling system
D-171206CMA01C
in the event of a limit switch failure. (See LEVEL LIMIT STOPS section)
components may occur if sensors aren't set properly.
Hillco Technologies, Inc.
Calibration
Joystick
Left/Right Clinometer
Carriage Angle Left Limit
Carriage Angle Right Limit
Fore/Aft Clinometer
A
Carriage Angle Right Limit
Manually lean the combine to the right
as far as possible. Have an assistant
watch for clearance between the ladder or
styling panel and the right tires
Press Enter to save the right limit
calibration point.
C
32
Saved
Sept, 2022