Table of Contents
Advertisement
Thermo Scientific
Switches
When the main power switch is on, the three switches on the control panel
function as follows:
1. START: Pressing the START switch when the unit is in either the stop
("IdL") or standby ("SbY") mode will put the unit into Run Mode.
2. STANDBY: Pressing the STANDBY switch when the unit is in either
the start (run) or stop ("IdL") mode will put the unit into a Standby
Mode.
3. STOP: Pressing the STOP switch when the unit is in either the start
(run) or Standby ("SbY") mode will put the unit into a Stop ("IdL")
Mode.
Display
In addition to displaying the temperature compensated (25°C) resistivity in
megohms-cm, the display also indicates operational modes and error
indicators. The following is what can appear on the display:
Note On initial start-up, the display may display "Er1". This is caused by
air around the resistivity cell and should soon be replaced by a resistivity
reading. If "Er1" does not go out after the pump has run for a minute or if
it appears any time while the EASYpure II is in operation, refer to the
"Troubleshooting" section of this manual.
SbY
Er1
rEC
Er2
IdL
Er3
AFL
Er4
FL5
Er5
FL4
FL3
FL2
FL1
Controls and Normal Operation
s
EASYpure® II
Section 7
7-3
Advertisement
Table of Contents
