Before Starting The Machine; Transport And Assembly; Set The Brake; Fill Up Fuel Tank - Nilfisk-Advance MH PE Series Instructions For Use Manual

MH PE/DE

3 Before starting the machine

3.1

Transport and assembly

3.2 Set the brake (only
machines with wheels
3.3

Fill up fuel tank

6
1. The safest way to lift the ma-
chine is to use a fork-lift truck
The arrows in the illustration
indicate the best places to
position the fork.
Every fuel-burning appliance,
such as pressure washers, de-
pends upon a proper mix of fuel
and air (by weight) for proper
combustion. Therefore some
adjustment of the air supply to
the burner may be necessary to
take account of altitude and the
resulting air pressure. This is
true whether your fuel is 'Natural
gas', Propane or Diesel.
Your Nilfisk hot water pressure
washer was thoroughly tested
and adjusted for optimum per-
formance before it left our fac-
tory. The factory is located at
approximately 200m (650 ft)
above sea level, and the com-
bustion settings are optimal for
that elevation.
If your location is higher than
1200m (3900 ft) above sea
level, your burner may require
re-adjustment for proper
performance and best fuel
economy. Contact your Dealer
or Nilfi sk for assistance.
1. Before using the cleaner for
the fi rst time, check it care-
fully for any faults or damage.
2. Run the machine only when
it is in perfect working condi-
tion.

3. Set the brake.

With the machine cold and
turned off:
1. Fill fuel tank from a clean
container with a fresh fuel or
Diesel EN 590 (Diesel with
bio diesel content up to 7%).
See chapter 1.
Tank capacity max. 57 l.
Use clean fuel only, free of
moisture and contamination.
Contact your dealer for fuel
source and type recommenda-
tions.
Diesel according to EN 590 (up
Original Instructions