GS09, Setting Up and Starting Up
Setup and Startup
for real-time rover
step-by-step
Step
Description
1.
Setting Up the Equipment
•
Insert the battery into GS09 antenna.
•
Screw GS09 antenna onto the top of the telescopic pole.
•
Ensure that the compression lock is not clamped.
•
Fully extend the telescopic pole and ensure that the snap-lock clicks
into its position. The snap-lock ensures that there is no slipping of the
telescopic pole.
•
Clamp the compression lock. The compression lock maintains straight-
ness.
•
Remove the plastic sleeve from the clamp (if using a carbon-fibre
pole). Slide the clamp onto the bottom part of the telescopic pole.
•
Fix the holder to the clamp with the tightening screw. Before tight-
ening, ensure that the holder is at a comfortable working height and
angle. This can be achieved by sliding the clamp along the pole and
rotating the holder about the clamp. Tighten the tightening screw.
•
Insert the CompactFlash card into CS09 field controller.
•
Insert the battery into CS09 field controller and GHT56 holder.
64