DFI G5C100-N User Manual page 82

3
BIOS Setup
IDE HDD Block Mode
Enabled The IDE HDD uses the block mode. The system BIOS
Disabled The IDE HDD uses the standard mode.
IDE DMA Transfer Access
This field is used to enable or disable the DMA transfer function of
an IDE hard drive.
On-Chip Primary PCI IDE and On-Chip Secondary PCI IDE
These fields allow you to enable or disable the primary and second-
ary IDE controller. The default is Enabled. Select Disabled if you want
to add a different hard drive controller.
IDE Recovery Time
This field is used to select the IDE recovery time.
IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto
Disabled
SATA Mode
IDE
AHCI This option configures the Serial ATA drives in AHCI
8 2
will check the hard disk drive for the maximum block
size the system can transfer. The block size will depend
on the type of hard disk drive.
The BIOS will automatically detect the settings for
you.
The BIOS will not detect these categories.
This option configures the Serial ATA drives in IDE mode.
mode.