DFI G5C100-N User Manual page 13

wake-on-lan
It is supported via the onboard LAN port or via a PCI LAN card
that uses the PCI PME (Power Management Event) signal. However,
if your system is in the Suspend mode, you can power-on the system
only through an IRQ or DMA interrupt.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-PS/2
tem.
Important:
The 5V_standby power source of your power supply must sup-
port ≥ 720mA.
wake-on-USB
from the S3 (STR - Suspend To RAM) state.
Important:
If you are using the Wake-On-USB Keyboard/Mouse function for
2 USB ports, the 5V_standby power source of your power sup-
ply must support ≥ 1.5A. For 3 or more USB ports, the
5V_standby power source of your power supply must support
≥ 2A.
The RTC installed on the system board allows your
rtc timer
system to automatically power-on on the set date
and time.
The system board is designed to meet the ACPI
ACPI STR
(Advanced Configuration and Power Interface) speci-
fication. ACPI has energy saving features that enables PCs to imple-
ment Power Management and Plug-and-Play with operating systems
that suppor t OS Direct Power Management. Currently, only Win-
® ® ® ® ®
dows 98/2000/ME/XP/Vista suppor ts the ACPI function. ACPI
when enabled in the Power Management Setup will allow you to use
the Suspend to RAM function.
This feature allows the network to remotely
wake up a Soft Power Down (Soft-Off) PC.
This function allows you to use the PS/2 key-
board or PS/2 mouse to power-on the sys-
This function allows you to use a USB key-
board or USB mouse to wake up a system
Introduction
1
13