Table of Contents
Advertisement
2
Hardware Installation
Serial Ports
COM 1
COM 2
COM 4
The system board is equipped with 3 onboard serial ports at loca-
tions CN9 (COM 1 and COM 2) and CN1 (COM 4). It is also
equipped with a 9-pin connector at location J15 (COM 3). The serial
ports are RS-232 and/or RS-485 (COM 4 only) asynchronous com-
munication ports with 16C550A-compatible UARTs that can be
used with modems, serial printers, remote display terminals, and
other serial devices.
To connect COM 3, please refer to the following description. The
serial port may be mounted on a card-edge bracket. Install the card-
edge bracket to an available slot at the rear of the system chassis
then insert the cable connector to J15. Make sure the colored stripe
on the ribbon cable is aligned with pin 1 of J15.
38
9 9 9 9 9
RI-
RTS-
CTS-
DSR-
GND
TD
DTR-
DCD-
RD
2 2 2 2 2 1 1 1 1 1
COM 3
Important:
If the LCD Display Panel that is connected to the LVDS LCD
Panel connector supports touch screen, DO NOT connect a
serial device to COM 3 because the touch screen function is
internally connected to COM 3.
Advertisement
Table of Contents
