DFI G5C100-N User Manual page 59

Power Connector
The 20-pin ATX main power connector must be inserted onto the
P1 connector. The system board requires a minimum of 100 Watt
power supply to operate. We recommend that you use a power
supply that complies with the ATX12V Power Supply Design Guide
Version 1.1.
Important:
The system board consumes a minimal amount of power. Due
to its low power consumption, you only need a 100W to
150W power supply. Every power supply has its minimum 150W 150W
150W 150W
load of power. If you use a greater than 150W power supply,
the power consumed by the system board may not attain its
minimum load causing instability to the entire system.
Hardware Installation
2 0
1 0
2
1 1
1
100W to 100W to
100W to 100W to
59