Precautions For Installation - i-PRO WV-CW304L Installation Manual

Precautions for installation

i-PRO Co., Ltd. assumes no responsibility
for injuries or property damage resulting
from failures arising out of improper
installation or operation inconsistent with
this documentation.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your particu-
lar environment.
• Make sure that the installation area is strong
enough to hold the product, such as a
concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• If a wall or ceiling board such as plaster
board is too weak to support the total
weight, the area shall be suf ficiently
reinforced.
Avoid installing this product in the
following locations.
• Locations where a chemical agent is used
such as a swimming pool.
• Locations subject to steam and oil smoke
such as a kitchen.
• Locations near flammable gas or vapor.
• Lo c ati o n s w h e re r a d i ati o n o r x- r ay
emissions are produced.
• Locations where corrosive gas is produced,
Locations where it may be damaged by
briny air such as seashores.
• Locations where the temperature is not
within –10 °C to +50 °C.
• Locations subject to vibrations ( This
product is not designed for on-vehicle
use.)
• Locations subject to condensation as the
result of severe changes in temperature.
Avoid installing this product in a place with
a high level of noise.
Installation near an air conditioner, an air cleaner,
a vending machine, or the like causes noise.
Avoid installing and connecting during a
lightning storm. Otherwise, an electric
shock or fire may be caused.
Do not damage the power plug or cable.
Keep the camera cable away from the
lighting cable.
Failure to observe this may cause noise.
Be sure to remove this product if it is not in
use.
Design and engineer the power supply
system to turn on/off the power of this
product.
The product has no power switch. When
installing the product, use a power supply
device equipped with the ON-OFF switch for
servicing.
Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
the installation area.
• Do not use an impact driver. Failure to
observe this may cause overtightening
and consequently damage to the screws.
• When a screw is tightened, make the
screw at a right angle to the surface. After
tightening the screws or bolts, perform
visual check to ensure tightening is
enough and there is no backlash.
Locally procure the screws
Screws are not supplied with this product.
Prepare the screws according to the material,
structure, strength and other factors of the
mounting area and the total weight of objects
to be mounted.
11