Table of Contents
Advertisement
Important:
• This video output is intended for confirmation of view angle, etc. during installation or repair
service, and not for recording or monitoring.
Note:
• Monitor output jack has higher priority than video output connector. Video cannot be output
through the video output cable after connecting the adjustment monitor.
Safety warning label
4 Repeat the steps (1) and (2) to adjust the camera angle.
(1) Loosen the panning lock screw and rotate the camera head horizontally to adjust panning.
(2) Loosen the tilting lock screw and rotate the camera head vertically to adjust tilting.
(3) Loosen the yow lock screw and rotate the camera head horizontally to adjust panning.
(4) Tighten the yow lock screw, panning lock screw and tilting lock screw after camera angle
adjustment.
Important:
• After camera angle adjustment, the yow lock screw, panning lock screw and tilting lock screw
shall be securely tightened. Recommended tightening torque: 1.8 N·m {1.33 lbf·ft}
Tilting lock screw
Yow lock screw
Panning lock screw
19
Advertisement
Table of Contents
