Table of Contents
Advertisement
Note:
• Do not put your fingers on the movable part where the safety warning label is pasted when the
camera angle is adjusted, unless your hands will be clamped when the front portion of camera
hangs down.
• Use a hexagonal wrench with width across flats of 3 mm (locally procured) to loosen or tighten
the yow lock screw, panning lock screw and tilting lock screw.
• Approximately 1 rotation of loosening the yow lock screw, panning lock screw and tilting lock
screw allows camera angle adjustment. Do not loosen the screws beyond necessity.
• The camera body shall be held when the yow lock screw, panning lock screw or tilting lock
screw is loosened.
• Focus adjustment shall be performed at the same time panning and tilting adjustments are
performed.
2
Adjust the angular field of view and the focus.
Adjust the angular field of view in accordance with the distance between the camera lens and a
photographic subject. These adjustments shall be performed together with the camera angle
adjustment.
1 Loosen the zoom knob and adjust to the best view angle between TELE and WIDE.
Note:
• The focus may not be adjusted smoothly when the zoom adjustment ring is extremely close to
the end of W direction (T direction). At this time, slightly adjust the zoom adjustment ring
towards the T direction (W direction), and then adjust the focus.
2 Tighten the zoom knob.
3 Adjust the focus knob to get the optimal angular field of view between NEAR and FAR.
4 Press the set button on the side of the camera, which will automatically focus.
Note:
• Press the set button to enter into the ABF function.
• If the set button is pressed continuously for more than 2 seconds, the setup menu will be
displayed.
20
CW324L
CW304L
CW324L
CW314L
CW304L
CW314L
Set button
Zoom knob Focus knob
Advertisement
Table of Contents
