Table of Contents
Advertisement
Note:
• The ABF function is not available over the entire focus range. Be sure to perform approximate
adjustment of the view angle before manual focusing, and then press the [ABF] button to
enable the ABF function.
• For the following subjects, select ELC control method, and then manually adjust the focus.
• Frequently moving subject
• Subject with large illuminance change
• Subject with low illuminance
• Too bright or reflective subject
• Subject through a window
• Place where the lens easily becomes dirty
• Subject with less contrast such as white wall
• Subject with remarkable depth
• Subject with heavy flicker
• Subject with horizontally parallel lines such as a shutter
3
Install the front cover.
Important:
• Make sure that the arrow on the location indicating label is aligned with the installation indicator
on the rear cover before the front cover is screwed tightly. Otherwise, the camera can not be
water proofed.
• Make sure that the sealing ring is not stripped or slanted, and if it occurs, please put the
sealing ring to where it is.
• Make sure there is no dust or other dirty things on the sealing rings, and if it occurs, please
remove them.
• Please strip the protective layer clung on the transparent portion of the front cover after
completing the installation, and after that, do not touch the transparent portion of the front
cover directly with your hands.
4
Install the sunshield.
Recommended tightening torque: 1.0 N·m {7.38 lbf·ft}
Rear cover
Front cover
Installation
Location
indicating mark
indicating label
Sunshield
21
Advertisement
Table of Contents
