Paper Does Not Feed From The Paper Tray; The Image On Paper Is Skewed; The Automatic Document Feeder Does Not Operate - Sharp DX-2500N Operation Manual

Problem
The paper misfeeds.
Paper does not feed
from the paper tray.
The image on paper is
skewed.
The automatic
document feeder does
not operate.
Point to check
Is A5 (5-1/2" x 8-1/2") size paper
loaded?
Has the correct paper size been set?
Did you add paper to the bypass tray?
Is the paper loaded correctly in the
paper tray?
In the Paper Tray Settings of the system
settings, are restrictions placed on the
trays that can be used in each mode
(copy, print, fax, Internet fax, and
document filing)?
Is too much paper loaded in the bypass
tray?
Are the bypass tray guides adjusted to
the width of the paper?
Are the original guides adjusted to the
width of the paper?
Have functions been disabled by the
administrator?
When loading A5 (5-1/2" x 8-1/2") size paper, place
the paper in the horizontal (A5R (5-1/2" x 8-1/2"R))
orientation.
If you are using a special size, be sure to specify the
paper size.
If the size of paper loaded in a tray was changed, be
sure to check the paper size setting.
ß System Settings > "Paper Tray Settings" > "Tray
Settings"
When adding paper, remove any paper remaining in
the bypass tray, combine it with the paper to be
added, and reload as a single stack.
If paper is added without removing the remaining paper,
a misfeed may result.
Set the guides to the size of the paper.
Make sure the height of the paper does not exceed the
indicator line.
Check the Paper Tray Settings and see if
checkmarks appear in the checkboxes of each
mode (Feeding Approved Job).
Functions without a checkmark cannot be used for
printing using that tray.
ß System Settings > "Paper Tray Settings" > "Tray
Settings" > "Change" >
Do not load more than the maximum number of
sheets.
The maximum number of sheets varies depending on
the paper type setting. For more information, see
"SPECIFICATIONS" in the Start Guide.
Adjust the bypass tray guides to the width of the
paper.
Adjust the original guides to the width of the paper.
Check with your administrator.
Some functions may have been disabled in the system
settings (administrator).
8-40
TROUBLESHOOTING
Solution
(Each mode)
Contents