SOLTEK 85ERV Instructions Manual page 57

85ERV / 85ERV-L
Configure SDRAM
Timing by SPD
SDRAM Frequency Allows you to set the SDRAM frequency.
SDRAM CAS# Latency With SDRAM Timing by SPD disabled, you can se-
SDRAM Bank Inter-
leave
SDRAM Burst Length With SDRAM Timing by SPD disabled, you can se-
SDRAM Command
Rate
Memory Hole Allows you to enabled / disabled (default) the sup-
AGP Mole Allows you to see the AGP Mode on board. The
AGP Read Synchroni-
zation
AGP Fast Write Allows you to enable / disable the AGP Fast Write
AGP Comp. Driving Allows you to Auto or manually set the AGP Comp.
SPD (Serial presence detect) is a device in memory
module for storing the module information such as
DRAM timing and chip parameters. If this option is
enabled, BIOS will access SPD automatically to
configure module timing. If disabled, DRAM timing
can be configured manually.
Choices: Auto; 200MHz; 266MHz
lect the SDRAM CAS# (Column Address Strode)la-
tency manually.
Choices: 2Clocks; 2.5 Clocks
This item allows you to enable / disable SDRAM
Bank Interleave function.
Choices: Disabled (default); Enabled
lect the SDRAM Burst length manually.
Choices: 8; 4
Allows you to set the SDRAM Command Rate.
Choices: 1T; 2T
port of Memory Hole which is reserved for ISA card.
default setting is Auto. This item support 4X/8X AGP
Mode
Allows you to enabled / disabled (default) the AGP
Read Synchronization function.
function
Driving.
64