Table of Contents
Advertisement
4. Hold tape
Hand Belt (HA-S95HB)
How to attach the Hand Belt
1. First check that the hand belt hook is oriented so that
the projections are facing towards you, as shown in
the illustration. Then push the hook ends into the strap
holes/anti-slip hook/hand belt hook mount in the
terminal.
Check that the hook is securely attached.
2. Push the metal hand belt fitting so that it engages with
the mount on the terminal, as shown in the illustration.
Check that the fitting is securely attached.
3. Feed the end of the hand belt through the hand belt
hook, fold it back to a suitable length and then fasten
it using the hook and loop fastener.
Precautions for Use
• If you are attaching both the anti-slip hook and the hand strap (or stylus), attach the
hand strap (or stylus) to the strap hole on the barcode reader side of the terminal.
• Do not attach the hand strap or stylus to the hand belt hook. Depending on how the
terminal is used, the strap or stylus could come loose.
• Continued use with the hand belt pulled very tight could result in the belt being
severed due to friction between the buckle and belt.
• Adjust the hook and loop fastener to a suitable length.
and remove the release film(
).
39
Advertisement
Table of Contents
