Using a SIM Card (DT-X450-WC21/WC31)
DT-X450 supports nanoSIM cards.
To use WAN functions, a SIM card must be installed.
The SIM card slot is located in the battery pack compartment, so you must remove the
battery pack before installing or removing a SIM card.
Installation
1. Turn the terminal off (shutdown).
2. Remove the battery pack.
(Steps 5 and 6 in the battery pack replacement procedure on page 20)
3. Flip back the SIM card cover.
4. Insert the SIM card into the card slot, as shown in the figure.
5. Close the SIM card cover.
6. Install the battery pack.
(Steps 2 and 3 in the battery pack installation procedure on page 19)
27