Casio DT-X450 Series User Manual page 52

Charging Battery Pack
Use the optional AC adaptor(AD-S12500A) to supply power to the charger.
1. Plug the connector from the AC adaptor into the AC adaptor jack on the charger with the
engraved side of the connector facing upwards. Push the connector firmly into the jack
until it clicks into place.
2. After connecting the power cable to the AC adaptor, plug the other end of it into an
AC outlet.
3. Turn on the power switch on the side of the charger. The power LEDs on the top of the
charger light red.
4. Place DT-X450 in the charger as illustrated so that the terminals on the bottom of the
DT-X450 make contact with the power contacts of the charger.
The power LEDs on the top of the charger light green and Charging Status LED lights
orange.
When placing the DT-X450 in the Multiple
Battery Charger, move the stylus retaining cord
and hand strap around to the back of the Multiple
Battery Charger to ensure they are not trapped in
the charger.
DT-X450 Charging status LED display
Orange:
Green:
Red:
Orange flashing: Charging (DT-X450 cannot start up because the charge remaining in the
50
AC adapter
AD-S12500A
Charging
Charging complete
Standby due to battery pack error or because the ambient temperature is
outside the charging temperature range.
(Charging begins when the temperature returns to the charging temperature
range.)
battery pack is too low. Wait until the charging status LED stops flashing
and lights orange.)
Power cord
AC-CORD3-EU
AC-CORD3-UK
AC-CORD3-AU