Zephir ZFS8093 Manual page 11

T
•
his appliance must only be used for the purpose for which it has been manufactured, therefore as a fan. The
manufacturer is not responsible for any damage caused by improper or incorrect use.
W
•
ARNING.The installation of this appliance can be done by qualified electricians ONLY.
S
•
ince the installation of the equipment sets, the power of the network must be done through flexible cable plug or
by-pole switch with contact opening distance of not less than 3 mm.
F
•
or the installation of the fan use a cable type H05 VVF.
D
•
o not make modifications of any kind to this appliance.
D
•
o not expose this appliance to the weather (rain, sun, etc.)
T
•
his appliance is for HOUSEHOLD USE ONLY.
I
•
nstall the appliance at an adequate distance from walls and other objects,etc.
D
•
o not expose the appliance to atmospheric agents such as rain, wind, snow, hail. Do not use outdoors.
R
•
egularly inspect the appliance for visible defects. If any faults are found, Do not use the appliance but contact
the Authorized Service Center.
I
•
f the appliance does not function correctly or there is a fault, contact authorized Service Center
I
•
n case the product fall down or it is damaged, or doesn't work as expected.contact the Authorized Service Center
E
•
nsure that the electrical system to which the appliance is connected conforms to applicable standards.
T
•
he appliance must be connected to an efficient earthing system in accordance with applicable electrical safety
standards. If in doubt, ask a qualified electrician for checking.
S
•
witch off the power before connecting or repairing the fan.
T
•
he electrical power supply/socket to which the appliance is to beconnected must be able to provide the
maximum electrical power required by the appliance. If it cannot do so, arrange for a professionally qualified
electrician to make the necessary modifications.
U
•
se a multi-polar switch with minimum contact distance of 3 mm to install the appliance.
S
•
witch off the appliance at the installation's main switch: