Table of Contents
Advertisement
The flame (oven)
Normal build-
does not burn
up of dirt
through all outlet
openings.
All dishes pre-
The thermo-
pared in the oven
stat is faulty.
burn within a
short period of
time.
The door panel
This is a nor-
steams up when
mal occur-
the oven heats
rence caused
up.
due to the
temperature
difference
The oven
The gas pres-
switches off.
sure is too
high or too
low
Power failure Check the oven's power supply.
Incorrect
installation
The cooling fan is
The cooling
not working.
fan is faulty.
Rotary spit does
The rotary
not work.
spit position is
not selected
The rotary
spit grilling is
not inserted.
Rotary spit
does not work
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Fault messages on the display
If an error message (starting with "
display, e.g.
–
, tap the
"ܠ
„ƒ
the error message. If necessary, reset the time.
If the error message does not go out after pressing the
button, switch off the appropriate fuse in the fuse
v
box and then switch it back on after 10 seconds.
If the error was a one-off, you can continue to use the
appliance as normal. If the error message appears
again, notify our after-sales service and quote the exact
error message and the E no. (product number) of your
appliance.
The burner must be profession-
ally cleaned.
Call the after-sales service.
No intervention needed; this has
no effect on performance.
Check whether the correct pres-
sure regulator is being used.
Make sure that the appliance was
installed according to installation
instructions.
Call the after-sales service.
Ensure that the rotary spit posi-
tion is switched on.
Ensure that the rotary spit is
inserted correctly.
Call the after-sales service.
") appears on the
"
button. This will reset
v
Replacing the bulb in the oven ceiling light
If the bulb in the oven light fails, it must be replaced.
Heat-resistant, 25 watt spare bulbs can be obtained
from our after-sales service or a specialist retailer. Only
use these bulbs.
:
Warning – Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the cold oven to prevent
1.
damage.
Unscrew the glass cover by turning it anti-clockwise.
2.
Replace the bulb with one of the same type.
3.
Screw the glass cover back in.
4.
Remove the tea towel and switch on the circuit
5.
breaker.
Trouble shooting
en
29
Advertisement
Table of Contents
