Table of Contents
Advertisement
Rails
en
pRails
W ith good care and cleaning, your appliance will retain
R a i l s
its appearance and remain fully functional for a long
time to come. This will tell you how to remove the
shelves and clean them.
Detaching and refitting the rails
The rails can be removed for cleaning. The oven must
have cooled down.
Detaching the rails
Lift up the front of the rail
1.
and unhook it (figure A).
2.
Then pull the whole rail forward
3.
and remove it (Fig. B).
4.
Clean the rails with cleaning agent and a sponge. For
stubborn deposits of dirt, use a brush.
Refitting the rails
First insert the rail into the rear socket, press it to the
1.
back slightly (figure A),
and then hook it into the front socket (figure B).
2.
The rails only fit on the right or the left side. Ensure that,
as shown in figure B, levels 1 and 2 are below and
levels 3, 4 and 5 are above. The pull-out rail must be
pulled out forwards.
28
3Trouble shooting
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 30
Fault
Possible
cause
The appliance
The fuse is
does not start.
faulty.
Power failure Check whether the kitchen light
Disruption of
gas supply
The electrical
The selector
heater does not
for the oven
work.
gas grill is
switched on.
The selectors
for the oven
control and
hybrid func-
tion are not
switched on.
The heater is
faulty
The time is flash-
Power failure. Reset the time.
ing on the display.
The settings on
The child-
the appliance
proof lock is
cannot be config-
activated.
ured. A key sym-
bol has lit up on
the display or
†'""
.
Fan position not
The grill
working.
selector is
switched on.
The fan posi-
tion is not
selected.
Fan fault
The oven light has
The oven light
failed
is faulty
The gas burner
Power cut or
does not ignite.
damp ignition
plugs
Remedy/notes
Check the fuse in the fuse box.
or other kitchen appliances are
working.
Make sure that the gas supply
valves are open.
Ensure that the selector for the
oven gas grill is switched off.
Switch on the selectors for the
oven control and hybrid function.
Call the after-sales service.
Deactivate the childproof lock by
pressing and holding the button
with the key symbol for approx. 4
seconds.
Make sure that the grill selector is
switched off.
Make sure that the fan position is
switched on.
Call the after-sales service.
Replace the oven light. (see sec-
tion entitled "Replacing the oven
light")
Light the gas burner with a gas
lighter or a match.
Do not operate the oven without
power.
Advertisement
Table of Contents
