Table of Contents
Advertisement
Operating the appliance
en
Switching on the double-flame burners
Always position the burner lid precisely on the burner
cup. The openings in the burner cup must remain
unobstructed at all times. All parts must be dry.
Power levels
You can use the selector to set the power between
maximum and minimum.
Position
Meaning
Off
Û
Maximum power
—
Minimum power
˜
Since the double-flame burners comprise two burners,
you can set the outer and inner flame continuously.
Operating and power levels (these may look different
depending on the appliance model):
If the flame goes out
Switch off the selector. Wait for one minute and switch
on again.
:
Warning – Fire hazard!
If the flame goes out, gas will escape. Never leave the
gas burner (hob) unattended while it is in use. Ensure
that there are no draughts.
18
Igniting
Outer and inner flame on
full power.
Outer flame on minimum,
inner flame on full power.
Inner flame on full power.
Inner flame on minimum.
If the gas burner does not ignite
In the event of a power failure or damp ignition plugs,
light the gas burner with a gas lighter or a match.
Switching off the gas burner
Turn the selector for the hob clockwise to the Off
position.
:
Warning – Caution!
If, after switching the appliance off, you turn the selector
while the oven is still hot, gas will escape. If you do not
turn the selector to the ignition position
seconds, the gas supply is shut off.
Warnings
It is normal to hear a soft whistling noise while the
burner is operating.
When first used, it is normal for the burner to give off
odours. This does not pose any risk and does not
indicate a malfunction. They will disappear in time.
An orange-coloured flame is normal. This is caused by
the presence of dust in the atmosphere, spilt liquids,
etc.
In the event of the burner flames being accidentally
extinguished, turn off the burner control and do not
attempt to re-ignite the burner for at least one minute.
A few seconds after the burner is switched off, a sound
(thud) will be produced. This is not a fault - this means
that the safety device is no longer operating.
Keep the burner as clean as possible. If the ignition
sparkers are dirty they will not light properly. Clean
them periodically using a small non-wire brush. Bear in
mind that the ignition sparkers must not suffer any
serious impacts.
Û
within 60
8
Advertisement
Table of Contents
