Replacing The Bulb In The Oven Ceiling Light; Glass Cover; After-Sales Service; E Number And Fd Number - Bosch HCA8544 0A Series Instruction Manual

Free standing cooker
Table of Contents

Advertisement

"
Error messages with
If an error message with
"
button. This cancels the error message. You may then have to
Error message
"‹‚‚
"‚‚†

Replacing the bulb in the oven ceiling light

If the bulb in the oven light fails, it must be replaced. Heat-
resistant, 40 watt spare bulbs can be obtained from our after-
sales service or a specialist retailer. Only use these bulbs.
:
Risk of electric shock!
Switch off the circuit breaker in the fuse box.
Place a tea towel in the oven when it is cold to prevent
1.
damage.
Remove the glass cover. To do this, press back the metal
2.
tabs with your thumb (Fig. A).
Unscrew the bulb and replace it with one of the same type
3.
(Fig. B).

After-sales service

Our after-sales service is there for you if your appliance needs
to be repaired. We will always find the right solution in order to
avoid unnecessary visits from a service technician.

E number and FD number

When calling us, please give the product number (E no.) and
the production number (FD no.) so that we can provide you with
the correct advice. The rating plate containing these numbers
can be found on the right-hand side of the oven door. You can
make a note of the numbers of your appliance and the
telephone number of the after-sales service in the space below
to save time should it be required.
E no.
O
After-sales service
is shown in the display, press the
Possible cause
A button has been pressed for too
long.
The temperature in the cooking
compartment is too high.
FD no.
reset the time. If the error is shown again, call the after-sales
service.
0
You can take remedial action yourself if the following error
messages are displayed.
Note/remedy
Press all buttons individually. Check that the but-
tons are clean. If the error message remains,
please contact the after-sales service.
The oven door locks. Wait until the cooking com-
partment has cooled down. Clear the error mes-
sage with the
Refit the glass cover. When doing this, insert it on one side
4.
and press firmly on the other side. The glass cover will click
into place.
Remove the tea towel and switch on the circuit breaker.
5.

Glass cover

You must replace a damaged glass cover. Suitable glass
covers may be obtained from the after-sales service. Please
specify the E number and FD number of your appliance.
Please note that there will be a fee for a visit by a service
technician in the event of a malfunction, even during the
warranty period.
Please find the contact data of all countries in the enclosed
customer service list.
To book an engineer visit and product advice
0344 892 8979
GB
Calls charged at local or mobile rate.
01450 2655
IE
0.03 € per minute at peak. Off peak 0.0088 € per
minute.
Rely on the professionalism of the manufacturer. You can
therefore be sure that the repair is carried out by trained service
technicians who carry original spare parts for your appliances.
0
button.
23

Advertisement

Table of Contents
loading

Table of Contents