Calculate - HP E1312A User Manual

Subsystem Syntax
Chapter 3
There are five math operations available (
one can be enabled at a time. Each performs a mathematical operation on every reading
or stores data on a series of readings. The selected math operation remains in effect
until you disable it, change functions, turn off the power, or perform a remote interface
reset. The math operations use one or more internal registers. You can preset the values
in some of the registers, while others hold the results of the math operation.
The following table shows the math/measurement function combinations allowed.
Each " " indicates an allowable combination. If you choose a math operation that is
X
not allowed with the present measurement function, math is turned off. If you select
a valid math operation and then change to one that is invalid, a "Settings conflict"
error is generated over the remote interface. For null and dB measurements, you
must turn on the math operation before writing to their math registers.
Valid Math/Measurement Function Combinations
DCV
AVERage X
DB X
DBM X
LIMit X
NULL X

CALCulate

:AVERage:AVERage?
:AVERage:COUNt?
:AVERage:MAXimum?
:AVERage:MINimum?
:DB:REFerence <
:DB:REFerence? [MIN|MAX]
:DBM:REFerence <
:DBM:REFerence? [MIN|MAX]
:FUNCtion AVERage|DB|DBM| LIMit|NULL
:FUNCtion?
value
:LIMit:LOWer <
:LIMit:LOWer? [MIN|MAX]
value
:LIMit:UPPer <
:LIMit:UPPer? [MIN|MAX]
:NULL:OFFSet <
:NULL:OFFSet? [MIN|MAX]
:STATe OFF|ON
:STATe?
AVERage
Measurements
ACV DCI ACI
X X X
X
X
X X X
X X X
value > |MIN|MAX
value
> |MIN|MAX
> |MIN|MAX
> |MIN|MAX
value > |MIN|MAX
Multimeter Command Reference
CALCulate
, , , , and
DB DBM LIMit NULL
Ω2W Ω4W
Freq Per
X X X
X X X
X X X
), only
Ratio
X X
X X
X
73