Current:ac:range - HP E1312A User Manual

CURRent:AC:RANGe

Parameters
Comments
CURRent:AC:RANGe?
Example
Chapter 3
[SENSe:]CURRent:AC:RANGe <
measurements.
Parameter Name Parameter Type
range
< >
•
To select a standard measurement range, specify range as the input signal's
maximum expected current. The multimeter then selects the correct range.
•
MIN selects the minimum range available with the
command: 1A.
MAX
•
You must select a range using
resolution.
•
Specifying a fixed range disables the autorange mode set by the
CURR:AC:RANG:AUTO
•
The CURR:AC:RANG
command on the same function.
CONFigure
•
Condition:
*RST
[SENSe:]CURRent:AC:RANGe? [MIN|MAX]
to the output buffer:
•
The present current range selected if
ranges available with the
CONFigure sets the 3A range, 3A is the range returned.
•
The minimum current range available (1A) if
•
The maximum current range available (3A) if
Query the AC Current Measurement Range
CURR:AC:RANG 3
CURR:AC:RANG?
enter statement
range selects the range for AC current
>
Range of Values
numeric 1A|3A|MIN|MAX
selects the maximum range available: 3A.
CURRent:AC:RANGe
command.
command overrides the range setting from a previous
CURR:AC:RANG 1
returns one of the following numbers
or
MIN
RANGe command are returned. For example, if
Select 3A range.
Query multimeter to return the present range.
Enter value into computer.
Multimeter Command Reference
Default Units
CURRent:AC:RANGe
before specifying
is not specified. Only the
MAX
MIN is specified.
MAX is specified.
amps
119