Abort - HP E1312A User Manual

Subsystem Syntax
Example
Comments
72 Multimeter Command Reference
The command subsystem removes the multimeter from the wait-for-trigger

ABORt

state and places it in the idle state.
is TRIGger:SOURce BUS
ABORt
Aborting a Measurement
CONF:VOLT:DC
TRIG:SOUR BUS
INIT
ABOR
•
does not affect any other settings of the trigger system. When the
ABORt
INITiate command is sent, the trigger system will respond as it did before
ABORt was executed.
•
ABORt returns the multimeter to the idle state for
"Trigger ignored" error is generated when a Group Execute Trigger (GET) bus
command or
*TRG
(which puts the multimeter into the idle state).
•
Related Commands:
•
*RST Condition: After a a
occurred.
is only effective when the trigger source
ABORt
.
Function: DC voltage.
Trigger source is BUS trigger.
Place multimeter in wait-for-trigger state.
Abort waiting for a trigger and place
multimeter in idle state.
common command is executed after an
INITiate , TRIGger
*RST , the multimeter acts as though an
ABORt
TRIGger:SOURce BUS
command
ABORt
ABORt
Chapter 3
. The
has